SonicWALL E6500 Manual de usuario descargar pdf (Pagina 41)

Page 40 Configuring L2 Bridge Mode

Configuring the Secondary Bridge Interface

Complete the following steps to configure the SonicWALL

appliance:

1. Navigate to the Network > Interfaces page from the

navigation panel.

2. Click the Configure icon in the right column of the X0 (LAN)

interface.

3. In the IP Assignment drop-down, select Layer 2 Bridged

Mode.

4. In the Bridged to drop-down, select the X1 interface.

5. Configure management options (HTTP, HTTPS, Ping,

SNMP, SSH, User logins, or HTTP redirects).

Note: Do not enable Never route traffic on the bridge-pair

unless your network topology requires that all packets

entering the L2 Bridge remain on the L2 Bridge

segments.

You may optionally enable the Block all non-IPv4

traffic setting to prevent the L2 bridge from passing

non-IPv4 traffic.

If You Are Following

Scenario...

Proceed to Section:

C - L2 Bridge Mode

Additional Deployment

Configuration - page 41

NSA_E6500_GSG.book Page 40 Wednesday, June 17, 2009 7:16 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 77 78

Sin comentarios

SonicWALL E6500 Manual de usuario Pagina 41